Other values are possible in exceptional circumstances with the aid of ENFX resistors. In all cases the actual setting is the next value down from the one calculated. The operating principle of the missing unit dialjx facility can be seen from Fig. Corresponding channels 1 and 3 and also channels 2 and 4 give alarm. DIALux family For lighting designer and manufacturer.

Author:Mur Totaur
Language:English (Spanish)
Published (Last):10 May 2008
PDF File Size:2.44 Mb
ePub File Size:8.6 Mb
Price:Free* [*Free Regsitration Required]

A typical return loss characteristic is shown in Fig. ETL41 Manual En This possibility has a positive influence on the cost of setting up telecontrol networks, because it avoids the need of separate equipment racks and auxiliary supplies.

In the case of short lines line attenuation. The scheme can be extended to four tripping channels by simply inserting a further relay interface. Of the possible PLC techniques, single sideband modulation with a 4 kHz spacing to make the best use of the available frequency bands and permitted transmitting powers, and the European practice, mainly for reasons of cost, of multiple use of PLC channels for speech, data and protection signals have become widely established.

Other filters for specific applications can be fitted subsequently as required. The room should be well ventilated. All renowned luminaire manufacturers offer digital product data for planning in DIALux. DIALux — Descargar The main disadvantage, however, is the intermodulation phenomena and associated cross-talk it causes. The power of teleprotection signals applied to the AUX. Corresponding channel gives alarm. The coupling unit includes the main coupling filter and protective devices.

The setting ranges marked may only be used for reductions of power and not for channel loading see Sections 9. Fully programmable VFT channel with DIL switch and jumper settings for baud rate, transmitting and re-ceiving frequencies and transmitter level.

Should one or several monitored parameters indicate an alarm condition, the corresponding LED lights on the P4LA, respectively on the unit concerned. Channels 2 and 4 give alarm. The circuits required for a four-wire service telephone are also provided. Other values are possible in exceptional circumstances with the aid of ENFX resistors.

The line of communication comprises: It is defined by the following equation: By making use of the pilot signal generated by the PLC equipment and the transmission of tripping dialu in the speech band, the NSD 50 requires no additional PLC bandwidth. All the functional blocks for processing transmitter and receiver speech signals and the associated signal logic are contained in this unit. The last section is concerned with system operating level and adjusting the operating level of the equipment.

Manual para el Aprovechamiento Forestal en Documents. This is necessary to confirm the design crite-ria used for engineering the system, respectively if the criteria were inaccurate, to take the appropriate cor-rective action. To allow the hinged frame to be fully opened without hindrance, avoid locating a cubicle in a corner.

This achieves the maximum SNR at the receiver. There are diapux two groups of signals each comprising two permissive and two direct transfer tripping signal, the latter having priority. The ratio between the power of the boosted teleprotection signal and the power of the test tone signal is defined as the boost ratio BR and is normally expressed in decibels. Cement floors and walls should be sealed with a suitable paint.

Other signals depend on type of fault. The available AF band can be used as required. Usb-prommer Commissioning Manual en-En Documents. The software makes professional lighting design easier and accessible to everyone. Related Articles


Manual dialux 4.13 español:



DIALux is the software for professional lighting design


Related Articles