Colourless film when dry. Mixing: 10 parts of lacquer to 1 part of hardener. After adding hardener leave for 10 minutes. Avoid reuse of mixed material beyond this time. Apply the lacquer to the floor sparingly and evenly, rolling out the lacquer promptly so as to avoid gluing the boards together. Ready for light traffic: 8 hours.
|Country:||Bosnia & Herzegovina|
|Published (Last):||24 May 2005|
|PDF File Size:||4.51 Mb|
|ePub File Size:||16.42 Mb|
|Price:||Free* [*Free Regsitration Required]|
Product Variations Description Junckers HP Commercial is a hard-wearing, 2-component water based polyurethane lacquer. Package size incl. Once it is applied and dries, it becomes a colourless coating film. Technical data Mixing 10 parts of lacquer to 1 part of hardener. Which means you should put ml of hardener per every liter of lacquer. Afterwards you have to add the hardener and stir the entire thing again, for a minimum of 45 seconds. Leave it to rest for about minutes and it should be ready for use.
Before starting off your work process with it, shake it a couple of more times, once again for a minimum of 45 seconds. The resulting mix should be used within a timeframe of 2 hours.
DO NOT apply by pouring out the lacquer directly on the floor. There is also a temperature requirement about the surface you are about to lay it on. The room can receive light traffic in 8 hours and will be fully cured after 3 days. Apply only 2 coats of lacquer per day. Tool cleaning and storage Rinse the tools with soap and water before the leftover residue dries. The surface has to be sanded in order to remove any dirt and irregularities.
After that you should vacuum thoroughly and wipe off with a well wrung cloth and clean water. Sand with grit sandpaper along the fibres of the wood. Vacuum the dust from the sanding and once again wipe off well with a cloth and clean water. Apply a coat of Junckers HP Commercial, leave to dry, and apply the final coat. Previously sealed floors You will have to begin by washing the floor with Junckers Sylva Neutralizer.
Then sand the floor by using a grit sandpaper. Vacuum all of the leftover dust and wipe off with a well wrung cloth and clean water. We advise you to do a trial application on a couple of spots, 2 coats at 4 hour intervals. After letting them dry for 24 hours, you can go back to them and check the adhesion by scraping with the edge of a coin. If everything is fine and the result is acceptable, the floor can be lacquered with one coat of Junckers HP Commercial.
You should use grain size to strip old coats. The leftover abrasion marks will then need to be removed with grit and then finally you should use a grit paper to obtain a perfectly smooth surface. You can also find this product in UltraMatt variation.
Junckers HP Commercial Floor Lacquer Commercial floors and wood floors with high footfall, will require industrial finishes. Floor refinishing projects can be very disruptive and in some types of wood floors, nearly impossible to do more than times. This product is known to outlast its competition, to be resistant to chemical reactions and to protect against scratches. Junckers HP Commercial Floor Lacquer is a water based two pack commercial floor finish recommended for schools, pubs, restaurants, sport rooms, public buildings, etc. It looks great, it dries fast and it can be applied over oil based wood stain.
Junckers HP Commercial Varnish, Satin, 4.5L